Designed and produced in collaboration with Andrew Henry of Henry Holsters, the Flatpack is a 5×2.5 inch injection molded plastic backboard through which elastic shock cord is routed in two loops to retain a flat-folded tourniquet. The knotted cord ends can be pulled tight and retained in the adjustment notches to increase security and take up any cord slack. The high viz deployment pull tabs are installed by untying the knots and threading the shock cord through the holes in the tabs, either in single or double tab configuration, and through whichever tab holes provide you with the desired tab size. The soft loops are attached with a screw and post, keeping the profile of the carrier slim, allowing for belt slide horizontal carry. The loops are spaced for horizontal MOLLE attachment, as well. Simply remove the screws, thread the loops through the MOLLE columns, and reattach. The short MALICE clips, as well as Blade-Tech MOLLE Locks are compatible with the Flatpack for vertical carry, using the four holes in the center of the carrier. Use the soft-loop mounting hardware to attach your vertical solution of choice.
Please see the Malice Clip addendum for details on Malice Clip installation: Flatpack MALICE Instructions
The PHLster Flatpack™ is 100% American Made and is backed by a two year warranty. Patent Pending. Flatpack™ is a registered trademark of PHLster LLC.
For further details of use and instructions, please refer to these two videos.
Introducing the PHLster Flatpack™:
How to flat-pack a windlass tourniquet: